Printronix P5000 Manual de Instruções descarregar pdf (Página 172)

172

Chapter 5 Section I: Replacement Procedures

Installation

CAUTION

To prevent electrostatic damage to electronic components, always wear

a properly grounded static wrist strap when you handle memory

modules and circuit boards.

NOTE: Flash SIMMs from one CMX controller board must be placed in the

same slot on a replacement CMX controller board. Installing flash

memory from one controller board to another does not transfer all

operating system software, so you must download the emulation

again.

1. Observing the correct pin orientation, install the new security PAL, if

required by the emulation. (See the chart on page 171 and Figure 24 on

page 173.)

2. Insert the memory module into the correct socket on the CMX controller

board:

a. Position the SIMM with the notched end toward the right side of the

CMX controller board. (See Figure 24, page 173.)

b. Press the SIMM into the socket with the top of the SIMM angled

away

from the center of the board. When the SIMM is seated in the socket,

gently push on the ends until it locks in the upright position.

3. Cabinet Models: Install the paper path (page 177).

Pedestal Models: Install the top cover assembly (page 161).

4. Download the emulation (page 130).

5. Return the printer to normal operation (page 107).

6. Using the configuration printout(s) you made in step 1 of the removal

procedure, reset and save the printer configuration(s). (Refer to the

User’s Manual.)

CT/IPDS/PGL/LP+ ä

CT/IPDS/VGL/LP+ ä

Emulation

Security PAL Number

123456

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 359 360

Sem comentários

Printronix P5000 Manual de Instruções Página 172