Printronix P5000 Manual de Instruções descarregar pdf (Página 31)

How to Clear LCD Messages

Troubleshooting Display Messages

WARNING

Always disconnect the AC power cord from the printer before doing a

maintenance procedure. Failure to remove power could result in injury

to you or damage to equipment. If you must apply power during

maintenance, you will be instructed to do so in the maintenance

procedure.

Three kinds of messages appear on the Liquid Crystal Display (LCD):

• Status messages

• Configuration menus and menu options

• Fault messages

NOTE: Most fault messages are cleared from the LCD by correcting the fault

condition and then pressing the CLEAR key. Fault messages that

can only be cleared by shutting down and restarting the printer are

indicated by an asterisk (*) appended to the message.

If printer logic detects a fault condition, three things happen:

• The status indicator on the control panel flashes on and off.

• The audible alarm beeps if it is enabled. Press CLEAR to silence the

alarm.

• The control panel LCD displays a fault message.

How to Clear LCD Messages

Find the message in the Message List below, go to the troubleshooting

procedure, and follow the numbered instructions. After correcting an error,

press the CLEAR key to clear the message and place the printer in the off-

line state.

If an error is not cleared, the printer will try to print again but will display the

error message until the error is cleared.

Table 2: Message List

Symptom

Troubleshooting

Procedure

06 HOST REQUEST page 39

08 HOLD PRINT

TIMEOUT

page 39

8.5V POWER FAIL * page 39

15 COMM CHECK page 39

15V CTL FAIL* page 40

22 INVALID ADDR page 40

23.5V CTL FAIL* page 40

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 359 360

Sem comentários

Printronix P5000 Manual de Instruções Página 31