Printronix P5000 Manual de Instruções descarregar pdf (Página 179)

Platen

179

Installation

IMPORTANT

The dowel pins protruding from the ends of the platen are the platen

shafts. The platen shafts are not of equal length. The platen must be

installed with the longer shaft on the right side.

1. Wipe the platen shafts clean of grease and debris.

2. Install two washers on the longer (right) platen shaft. (See Figure 25

below.)

3. Apply bearing lubricant to both platen shafts.

Figure 25. Installing the Platen Adjust Bracket

4. Make sure the two wear saddles are set flush into the corners of the

mechanism base platen seat. (See Figure 26 below.)

5. Apply a layer of bearing lubricant 1/4 inch high to the seat of each wear

saddle, making the layer as wide as the saddle and touching the rear

angled surface.

6. Install one platen adjust bracket onto the longer platen shaft, with the

screw at the top of the bracket.

7. Place the other bracket onto the left side mechanism base platen seat so

that the mechanism base platen seat is between the flanges of the

bracket.

8. Insert the shorter platen shaft through the left adjust bracket and through

the opening in the left side plate. Rotate the longer shaft into the opening

in the right side plate and position the adjustment brackets as shown in

Figure 26.

Platen Shaft

(Right Side)

Washer

Ironer Bracket

Platen Adjust

Bracket

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 359 360

Sem comentários

Printronix P5000 Manual de Instruções Página 179